CX-7 FWD L4-2.3L Turbo (2010)
a. Disconnect the negative battery cable.
b. Remove the battery.
c. Remove the battery tray.
d. Remove the under cover.
e. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.
f.
Drain the ATF. See: Automatic Transmission/Transaxle/Service and Repair/Procedures
g. Remove the oil cover. See: Automatic Transmission/Transaxle/Valve Body/Service and Repair/Removal and Replacement/Control Valve
Body Removal/Installation - FS5A-EL
h. Remove the secondary control valve body. See: Automatic Transmission/Transaxle/Valve Body/Service and Repair/Removal and
Replacement/Control Valve Body Removal/Installation - FS5A-EL
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Add ATF. See: Automatic Transmission/Transaxle/Service and Repair/Procedures
5. Perform the "Mechanical System Test". See: Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Mechanical System Test
6. Perform the "Road Test". See: Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Road Test
