CX-7 FWD L4-2.3L Turbo (2010)
Shift Solenoid: Testing and Inspection
Solenoid Valve Inspection - AW6A-EL, AW6AX-EL
SOLENOID VALVE INSPECTION [AW6A-EL, AW6AX-EL]
Resistance Inspection (On-Vehicle Inspection)
CAUTION:
-
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the
connector when disconnecting.
-
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
3. Remove the TCM. See: Control Module/Service and Repair/TCM Removal/Installation - AW6A-EL, AW6AX-EL
4. Measure the resistance between the following terminals.
-
If there is any malfunction, inspect the coupler component.
-
If the coupler component is normal, replace the control valve body. See: Valve Body/Service and Repair/Removal and Replacement/Control
Valve Body Removal/Installation - AW6A-EL, AW6AX-EL
Solenoid valve resistance (ATF temperature: 20 °C {68 °F})
5. Install the TCM. See: Control Module/Service and Repair/TCM Removal/Installation - AW6A-EL, AW6AX-EL
6. Install the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair