CX-7 FWD L4-2.3L Turbo (2010)
Transmission Speed Sensor: Testing and Inspection
Input/Turbine Speed Sensor Inspection - FS5A-EL
INPUT/TURBINE SPEED SENSOR INSPECTION [FS5A-EL]
CAUTION:
-
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
On-Vehicle Inspection
1. Disconnect the input/turbine speed sensor connector.
a. Disconnect the negative battery cable.
b. Disconnect the input/turbine speed sensor connector.
2. Measure the resistance between input/turbine speed sensor terminals A and B.
-
If there is any malfunction, replace the input/turbine speed sensor. See: Service and Repair/Input/Turbine Speed Sensor Removal/Installation -
FS5A-EL
Input/turbine speed sensor specification
-
250-650 ohms
Off-Vehicle Inspection
1. Measure the resistance between input/turbine speed sensor terminals A and B.
-
If there is any malfunction, replace the input/turbine speed sensor. See: Service and Repair/Input/Turbine Speed Sensor Removal/Installation -
FS5A-EL
Input/turbine speed sensor specification
-
250-650 ohms
