CX-7 FWD L4-2.3L Turbo (2010)
8. Insert the a 1.5mm {0.059 in} round bar or similar into hole A with the slider pin fully pushed in.
9. Fully pull the end of the interlock cable.
10. Push the a 1.5mm {0.059 in} round bar or similar into hole B and hole C of the lock unit until it passes through.
11. Disconnect the brake switch connector.
12. Remove the brake switch. See: Brakes and Traction Control/Brake Pedal Assy/Service and Repair
13. Install a new brake switch. See: Brakes and Traction Control/Brake Pedal Assy/Service and Repair
CAUTION:
-
Do not connect the brake switch connector until the interlock cable adjustment is completed.
14. Install the lock unit to the bracket. See: Shifter A/T/Service and Repair
15. Rotate the slider pin to release the lock and verify that it slides freely.
16. Verify that the slider pin contacts the brake pedal stopper rubber and rotate the slider pin to lock.
