CX-7 FWD L4-2.3L Turbo (2010)
Oil Pipe, Hose Clamp, Oil Hose Installation Note
1. Apply compressed air to the cooler-side opening, and blow any remaining grime and foreign material from the cooler pipes. Compressed air
should be applied for no less than 1 min.
2. Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown in the figure.
NOTE:
-
If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose camp.
3. Install the new hose clamp onto the hose.
4. Verify that the hose clamp does not interfere with any other components.
Oil Cooler Removal/Installation - FS5A-EL
OIL COOLER REMOVAL/INSTALLATION [FS5A-EL]
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
3. Remove the under cover.
4. Drain the ATF. See: Service and Repair/Procedures
5. Drain the engine coolant. See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
6. Remove in the order indicated in the table.
