CX-7 FWD L4-2.3L Turbo (2010)
-
If there is any malfunction, inspect the coupler component.
-
If the coupler component is normal, replace the ATX. See: Service and Repair/Removal and Replacement/Automatic Transaxle
Removal/Installation - AW6A-EL, AW6AX-EL
6. Install the TCM. See: Control Module/Service and Repair/TCM Removal/Installation - AW6A-EL, AW6AX-EL
7. Install the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
8. Connect the negative battery cable.
9. Perform the neutral position learning. See: Transmission Control Systems/Testing and Inspection/Programming and Relearning
Off-Vehicle Inspection
CAUTION:
-
Do not damage the terminals.
1. Connect the VSS terminal 2 to the battery positive terminal, connect the battery negative terminal to VSS terminal 1 through an ammeter set to a
resistance of 100 ohm.
2. Measure the current while waving a magnet back and forth over the top of the VSS (less than 5 mm {0.197 in}).
-
If there is any malfunction, replace the VSS. See: Powertrain Management/Computers and Control Systems/Sensors and Switches -
Computers and Control Systems/Vehicle Speed Sensor/Service and Repair/Vehicle Speed Sensor (VSS) Removal/Installation - AW6A-EL,
AW6AX-EL
VSS
