CX-7 FWD L4-2.3L Turbo (2010)
9. Remove the tubular pin and O-ring.
Secondary Control Valve Body On-Vehicle Installation
1. Install the tubular pin and new O-rings to the transaxle case.
2. Install the secondary control valve body.
3. Tighten the bolts and GND as shown to install the secondary control valve body.
Tightening torque
-
8-10 Nm {82-101 kgf-cm, 71-88 in-lbf}
Bolt length measured from below the head
4. Connect each solenoid valve connector.
