CX-7 FWD L4-2.3L Turbo (2010)
5. Separate the right side drive shaft from the joint shaft by tapping on a bar inserted between them.
Front Drive Shaft Clip Installation Note
1. Install a new clip onto the drive shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on
installation.
2. After installation, measure the outer diameter. If it exceeds the specification, repeat Steps 1-2 using a new clip.
Clip outer diameter specification
-
34.0 mm {1.34 in} max.
Front Drive Shaft Installation Note
CAUTION:
-
The sharp edges of the drive shaft can slice or puncture the oil seal. Be careful when installing the drive shaft to the transaxle.
-
The oil seals are damaged easily if this procedure is not done correctly.
Left side
1. Apply grease (L2Y1 33247) to the wheel bearing inner race and drive shaft contact surface (Area A in figure).
2. Insert the drive shaft into the wheel hub.
3. Apply transaxle oil to the oil seal lip.
4. Push the drive shaft into the transaxle.
