CX-7 FWD L4-2.3L Turbo (2010)
Joint Shaft Removal Note
1. Separate the right side drive shaft from the joint shaft by tapping on a brass bar inserted between them.
2. Remove the bolts.
CAUTION:
-
The sharp edges of the joint shaft can slice or puncture the oil seal. Be careful when removing the joint shaft from the transaxle.
3. Pull the joint shaft straight out.
Joint Shaft Clip Installation Note
1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on
installation.
2. After installation, measure the outer diameter. If it exceeds the specification, repeat Step 1 using a new clip.
