CX-7 FWD L4-2.3L Turbo (2010)
Quarter Window Glass: Service and Repair
Side Window Glass Removal
SIDE WINDOW GLASS REMOVAL
1. Remove the A-pillar lower trim. (See See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/A-Pillar Lower Trim
Removal/Installation)
2. Remove the A-pillar trim. (See See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/A-Pillar Trim Removal/Installation
)
3. Apply protective tape along the edge of the body and the side window glass.
Not Reusing Windshield
NOTE:
-
For the areas of the sealant that are difficult to cut, use thepiano wire and follow the procedure under "Reusing Windshield".
1. Cut out the sealant all around the glass from inside the vehicle using a sealant remover.
WARNING:
-
Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
2. Remove the side window glass.
Reusing Windshield
WARNING:
1
Using the piano wire with bare hands can cause injury. Always wear gloves when using thepiano wire.
1. Avoiding the pin on the inside of the vehicle, insert the piano wire which has been cut to sufficient length.
2. Wind each end of the piano wire around a bar.
