CX-7 FWD L4-2.3L Turbo (2010)
7. If the sealant has come off completely in any one place, apply some primer after degreasing, and allow it approx. 30 min to dry. Then apply 2 mm
{0.079 in} thickness of new sealant.
8. Clean and degrease the bonding surface along the perimeter of the body.
9. Apply body primer on the body as shown in the figure, then allow it to dry for approx. 30 min.
CAUTION:
-
To prevent weakening of the primer adhesion, keep the bonding surface free of dirt, moisture, and grease. Do not touch the surface with your
hand.
10. After the primer has dried, apply 11 mm {0.43 in} in thickness,5 mm {0.20 in} in width of sealant using a sealant gun. Where it is not applied
properly, correctly apply it using a spatula.
11. Insert the positioning pins to the body and install the quarter window glass.
12. Install the following parts:
a. D-pillar trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/D-Pillar Trim Removal/Installation
b. C-pillar trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/C-Pillar Trim Removal/Installation
