CX-9 AWD V6-3.7L (2008)
Power Trunk / Liftgate Hazard Sensor: Service and Repair
POWER LIFTGATE (PLG) TOUCH SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Liftgate upper trim
2. PLG arm
3. Liftgate side trim
4. Liftgate lower trim
3. Disconnect the PLG touch sensor connector.
4. Remove the screws.
5. Remove the PLG touch sensor.
6. Install in the reverse order of removal.
