CX-9 AWD V6-3.7L (2008)
^
Be sure to align tie wrap with the side wall of the connector box (E) and that the distance from the tie wrap to the existing band (F) is 30-35mm
(1.2-1.4 in.).
^
Cut the tie wrap leaving 5mm (0.2 in) from the tie wrap locking head (G).
NOTE:
^
The existing band clip (A) may come off during the repair, but it is not necessary to refasten it to the original location. If the band clip does come off,
simply remove and discard it.
4. Reinstall the front lower cover by tightening the two (2) screws.
NOTE:
Be careful not to pinch the harness between the covers while installing the front lower cover.
5. If applicable, reconnect the negative battery cable.
6. Lower the front and rear portions of the seat cushion to their bottom position. Confirm that the clearance between the front cover bracket and seat
