CX-9 AWD V6-3.7L (2008)
1. Place an alignment mark on the brake pipe and DSC/RSC HU/CM
2. Apply protective tape to the DSC/RSC HU/CM connector to prevent brake fluid from entering.
3. Remove the brake pipe.
DSC/RSC HU/CM Component Installation Note
1. Insert the DSC/RSC HU/CM bracket tab to the vehicle frame hole as shown in the figure.
2. Install the DSC/RSC HU/CM component.
Brake Pipe Installation Note
1. Align the marks made before removal and install the brake pipe to the DSC/RSC HU/CM and brake pipe joint referring to the figure.
2. Tighten the brake pipe to the specified torque using the SST (49 0259 770B) and the commercially available flare nut wrench.
DSC/RSC HU/CM Connector Installation Note
1. Install the DSC/RSC HU/CM connector using the following procedure:
1) After verifying that the lock lever is locked by the lower tab, connect the DSC/RSC HU/CM connector to the DSC/RSC HU/CM
2) Pull up the lock lever by pressing the lower tab, and release the lock.
3) Pull up the lock lever and lock it using the upper tab.
