CX-9 AWD V6-3.7L (2008)
Yaw Rate Sensor: Service and Repair
COMBINED SENSOR REMOVAL/INSTALLATION
Warning
^
If the DSC/RSC sensor initialization procedure is not completed, it could result in an unexpected accident due to the DSC/RSC being
inoperative. Therefore, after the combined sensor is replaced, always perform the DSC/RSC sensor initialization procedure to ensure
proper DSC/RSC operation.
Caution
^
The internal parts of the combined sensor could be damaged if dropped. Be careful not to drop the combined sensor. Replace the
combined sensor if it is subjected to an impact. Also, do not use an impact wrench or other similar air tools when removing/installing the
sensor.
1. Remove the second-row seat (RH).
2. Remove the edge cover.
3. Remove the long slider cover.
4. Separate the floor carpet at the area shown in the figure.
Caution
^
When separating the floor carpet, the wiring harnesses under the floor carpet could be damaged. Separate the floor carpet while
lifting it so as not to damage the wiring harnesses.
5. Partially peel back the floor carpet from where it is separated as shown in the figure.
6. Remove the rear heat duct No.4.
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
9. After installation, perform the DSC/RSC sensor initialization procedure. (See DSC/RSC SENSOR INITIALIZATION PROCEDURE.)
