CX-9 AWD V6-3.7L (2008)
Windshield Washer Switch: Removal and Replacement
Wiper and Washer Switch
WIPER AND WASHER SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the lower column cover.
3. Put aside the upper column cover.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
Combination Switch
COMBINATION SWITCH REMOVAL/INSTALLATION
WARNING: If the negative battery cable or the steering angle sensor connector is disconnected, the stored initial position of the steering angle
sensor will be cleared and the DSC will not operate properly, making the vehicle unsafe to drive. Perform the steering angle sensor
initialization procedure after connecting the negative battery cable.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the following parts.
1. Driver-side air bag module
2. Steering wheel
3. Lower column cover
4. Put aside the upper column cover.
5. Remove in the order indicated in the table.
6. Disconnect the steering angle sensor connector.
7. Install in the reverse order of removal.
