CX-9 AWD V6-3.7L (2008)
Band Control Solenoid Valve: Testing and Inspection
SOLENOID VALVE INSPECTION [AW6A-EL, AW6AX-EL]
Resistance Inspection (On-Vehicle Inspection)
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the TCM.
4. Measure the resistance between the following terminals.
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, replace the control valve body.
Solenoid valve resistance (ATF temperature: 20°C (68°F))
5. Install the TCM.
6. Install the air cleaner component.
7. Connect the negative battery cable.