CX-9 AWD V6-3.7L (2008)
Transmission Cooler: Removal and Replacement
OIL COOLER REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL]
1. Disconnect the negative battery cable.
2. Drain the ATF into a container.
3. Drain the engine coolant.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add the engine coolant.
7. Add ATF to the specified level.
8. Connect the negative battery cable.
9. Inspect for oil leakage from the oil pipes and oil hoses.
10. Inspect for coolant from the hoses.
11. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION [MZI-3.7].)
12. Inspect the ATF level and condition. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [AW6A-EL, AW6AX-EL].) See: Testing
and Inspection/Component Tests and General Diagnostics/Automatic Transaxle Fluid (ATF) Inspection
13. Perform the line pressure test. (See MECHANICAL SYSTEM TEST [AW6A-EL, AW6AX-EL].) See: Transmission Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Mechanical System Test
