CX-9 AWD V6-3.7L (2008)
7. Using a plastic hammer, tap the control valve body cover to remove it.
Caution:
^
Be careful not to damage the solenoid valves and connectors.
^
Do not pull the wiring harnesses when removing the connector.
Note:
^
Disconnect the solenoid connector according to the following procedure:
1. Insert a precision screwdriver from the backside into the connector as shown in the figure.
2. Pry the screwdriver in the direction of the arrow and disconnect the connector.
Caution:
^
Do not damage the solenoid valves and connectors with the screwdriver.
^
When disconnecting connectors, grasp the connectors, not the harnesses. Otherwise, the harnesses may be pulled out of the connector
causing poor contact.