CX-9 AWD V6-3.7L (2008)
Installation
WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
CAUTION: If a door is opened or closed when all the window glass is closed, the resulting change in air pressure could cause the sealant to
crack preventing the proper installation of the glass. Keep the door glass open until the quarter window glass installation is completed.
1. Remove sealant along the perimeter of the glass using a razor or scraper. (when reusing the glass)
2. Clean and degrease the ceramic part along the perimeter of the glass.
3. Inspect the glass for cracks. If it is cracked, chamfer it using sandpaper.
4. If the glass is reused, attach the pins and fastener to the glass as shown in the figure. Align with the alignment marks marked before removing the
glass.
5. Apply glass primer along the hollowed marks in the ceramic coating on the new glass, along the sealant tracks on the reused glass, then allow it to
dry for approx. 30 min.
CAUTION: To prevent weakening of the primer adhesion, keep the bonding surface free of dirt, moisture, and grease. Do not touch the
surface with your hand.
NOTE: Apply primer to the hollowed marks in the ceramic coating.
6. Cut away the old sealant using a razor or scraper so that 1-2 mm (0.04-0.079 in) thickness of sealant remains along the perimeter of the frame.
7. If the sealant has come off completely in any one place, apply some primer after degreasing, and allow it approx. 30 min to dry. Then apply 2 mm
(0.079 in) thickness of new sealant.
8. Clean and degrease the bonding surface along the perimeter of the body.
