Mazdaspeed3 L4-2.3L Turbo (2010)
9. Remove the clip by pulling it in the direction of the arrow shown in the figure.
10. Disconnect the connector shown in the figure.
11. While pressing the tab shown in the figure, pull the bracket in the direction of the arrow and remove it.
12. Remove the BCM.
13. Install in the reverse order of removal.
MTX
1. Perform the BCM configuration when replacing it. See: Testing and Inspection/Programming and Relearning/Body Control Module (BCM)
Configuration
2. Disconnect the negative battery cable.
3. Remove the following parts:
