Mazdaspeed6 L4-2.3L Turbo (2006)
Rear Door Panel: Service and Repair
REAR DOOR TRIM REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Open the cap using a small screwdriver, then remove the screw.
3. Remove the inner handle cover.
4. Remove the cover, then remove screws.
5. Disengage clips A from the rear door using a fastener remover.
6. Pull the rear door trim upward, then disengage tabs B from the rear door.
7. Disconnect the power window sub switch connector.
8. Remove the rear door trim.
9. Remove the switch panel from the rear door trim.
10. Install in the reverse order of removal.
