Mazdaspeed6 L4-2.3L Turbo (2006)
Warning:
^
Removing the crossmember is dangerous. The crossmember component could fall and cause serious Injury or death. Verify that the lack
securely supports the crossmember component before removing the crossmember bracket.
1. Support the crossmember component with a jack and remove the nuts.
2. Remove the crossmember bracket.
Front Crossmember Bushing Removal Note
1. Mark the crossmember as shown in the figure (rear upper side only).
2. Remove the bushings using flathead screwdriver, being careful not to damage the front crossmember.
Front Crossmember Bushing Installation Note
1. Set the bushings as shown in the figure.
Note:
^
The bushings must be installed with correct orientation as shown, or increased noise and vibration may result.
Front Side
