Mazdaspeed6 L4-2.3L Turbo (2006)
Rear Cross-Member: Service and Repair
Rear Crossmember Removal/Installation
REAR CROSSMEMBER REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the-vehicle.
1. Remove the pre-silencer.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the rear wheel alignment.