Mazdaspeed6 L4-2.3L Turbo (2006)
Sunroof / Moonroof Module: Service and Repair
Sunroof Unit
Removal and Installation
SUNROOF UNIT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Partially peel back the seaming welt.
3. Remove the following parts:
1. Microphone (vehicles with car-navigation system)
2. Sunroof seaming welt (vehicles with sunroof only)
3. A-pillar trims
4. Upper anchor of the front seat belt
5. Front scuff plate
6. Rear scuff plate
7
B-pillar lower trims
8. B-pillar upper trims
9. C-pillar trims
10. D-pillar trims (Sport Wagon)
11. Front and rear map lights
12. Cargo compartment light
4. Disconnect the auto-dimming mirror connector. (vehicles with auto-dimming mirror only)
5. Remove the sunvisors.
6. Remove the assist handle.
7. Remove the headliner.
8. Remove the glass panel.
9. Disconnect the front and rear drain hose from the sunroof frame.
10. Remove the bolt A, and then remove the rear set bracket.
11. Remove the bolt B and nuts, and then remove the sunroof unit.
12. Install in the reverse order of removal.
13. Adjust the glass panel.
Disassembly and Assembly
SUNROOF UNIT DISASSEMBLY/ASSEMBLY
