Mazdaspeed6 L4-2.3L Turbo (2006)
Sunroof / Moonroof Module: Service and Repair
Front Drain Hose
FRONT DRAIN HOSE REMOVAL
1. Disconnect the negative battery cable.
2. Partially peel back the seaming welt.
3. Remove the following parts:
1. Microphone (vehicles with car-navigation system)
2. Sunroof seaming welt (vehicles with sunroof only)
3. A-pillar trims
4. Upper anchor of the front seat belt
5. Front scuff plate
6. Rear scuff plate
7. B-pillar lower trims
8. B-pillar upper trims
9. C-pillar trims
10. D-pillar trims (Sport Wagon)
11. Front and rear map lights
12. Cargo compartment light
4. Disconnect the auto-dimming mirror connector. (vehicles with auto-dimming mirror only)
5. Remove the sunvisors.
6. Remove the assist handle.
7. Remove the headliner.
8. Disconnect the front drain hose from the sunroof frame.
9. Remove the front drain hose from the
10. Pull the front drain hose into the room
11. Remove the front drain hose.
FRONT DRAIN HOSE INSTALLATION
CAUTION: If the front drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and
after installation of the trims and the headliner, always make sure there is no interference with the front drain hose. Fix any problem if found.
1. Apply soapy water to the front drain hose inserting area.
2. Insert one end (the wider end) of the front drain hose into the sunroof frame.
3. Install the front drain hose to the clips, parallel to the pillar and free of slack.
4. Insert the front drain hose joint into the hinge pillar inner hole.
5. Install the headliner.
6. Install the assist handle.
7. Install the sunvisors.
8. Connect the auto-dimming mirror connector. (vehicles with auto-dimming mirror only)
9. Install the following parts:
1. Cargo compartment light
2. Front and rear map lights.
3. D-pillar trims (Sport Wagon)
4. C-pillar trims
5. B-pillar upper trims
6. B-pillar lower trims
7. Rear scuff plate
8. Front scuff plate
9. Upper anchor of the front seat belt
