Mazdaspeed6 L4-2.3L Turbo (2006)
Sunroof / Moonroof Module: Service and Repair
Rear Drain Hose Installation
REAR DRAIN HOSE INSTALLATION
CAUTION: If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and
after installation of the trims and the headliner, always
make sure there is no interference with the rear drain hose. Fix any problem if found.
1. Apply soapy water to the rear drain hose inserting area.
2. Insert one end (the wider side) of the rear drain hose into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of slack.
4. Insert the rear drain hose joint into the rear pillar inner hole.
5. Install the trunk side trim.
6. Install the trunk side upper trim
7. Install the headliner.
8. Install the assist handle.
9. Install the sunvisors.
10. Connect the auto-dimming mirror connector. (vehicles with auto-dimming mirror only)
11. Install the following parts:
1. Cargo compartment light
2. Front and rear map lights
3. D-pillar trims (Sport Wagon
4. C-pillar trims
5. B-pillar upper trims
6. B-pillar lower trims
7. Rear scuff plate
8. Front scuff plate
9. Upper anchor of the front seat belt
10. A-pillar trims
11. Sunroof seaming welt (vehicles with sunroof only)
12. Microphone (vehicles with car-navigation system)
12. Install the seaming welt.
