Mazdaspeed6 L4-2.3L Turbo (2006)
Power Trunk / Liftgate Lock Switch: All Technical Service Bulletins
Body - Trunk Lid Request Switch Inoperative
Bulletin No.: 09-016/08
Last Issued: 05/13/2008
Subject:
TRUNK LID REQUEST SWITCH INOPERATIVE - NO DTCs
BULLETIN NOTE:
This bulletin supersedes the previous bulletin 09-023/07 issued 07/05/07. The REPAIR PROCEDURE has been revised.
APPLICABLE MODEL(S)/VINs
2006 - 2007 Mazdaspeed6 vehicles with VINs lower than JM1GG****7*109258 (produced before Feb. 5, 2007) equipped with Advanced Keyless
System
DESCRIPTION
Some vehicles may experience an intermittent or inoperative trunk request switch operation, with no problems with the driver and/or passenger door
handle request switches. This condition may be the result of water/salt entering the trunk lid request switch through the lead wires.
The request switch has been improved to prevent this concern by changing the sealing surface of the lead wires from a clear epoxy to a black urethane.
Customers having this concern should have their vehicle repaired using the following repair procedure.
REPAIR PROCEDURE
1.
Verify customer concern.
2.
Using M-MDS (Mazda Modular Diagnostic System), monitor the trunk lid request switch PID (REQ_SW_BK) and check for the presents of any
DTC's.
-
If trunk lid request switch PID does not change from On/Off when pressing and releasing the request switch, and no DTC's are present, replace
the trunk lid request switch according to Workshop Manual (section 09-14 REQUEST SWITCH REMOVAL/INSTALLATION).
-
If trunk lid request switch PID does change from On/Off when pressing and releasing the request switch, (whether DTC's are present or not),
refer to the Workshop Manual for further diagnostics related to the advanced keyless entry system.
-
If DTC B1131 (keyless antenna - exterior, rear) is present, refer to Service Bulletin 09-015/08 (Door Or Trunk Lid Request Switch Inoperative
Due To Failed Advanced Keyless Antenna - DTC B1131).
3.
If negative battery cable was disconnected during repair, proceed to "Power Window Initialization Procedure" to restore "anti-pinch" and "auto
open/close" window features before returning vehicle to customer or dealer inventory.
4.
Verify repair.
POWER WINDOW INITIALIZATION PROCEDURE
1.
Turn ignition to ON position.
