Mazdaspeed6 L4-2.3L Turbo (2006)
Electronic Brake Control Module: Service and Repair
ABS/TCS HU/CM Removal/Installation
ABS/TCS HU/CM REMOVAL/INSTALLATION
Caution:
^
When replacing the ABS/TCS HU/CM, the configuration procedure must be done before removing the ABS/TCS HU/CM. If the configuration is
not completed before removing the ABS/TCS HU/CM, TCS will not work properly after installation of the ABS/TCS HU/CM.
^
Do not drop the ABS/TCS HU/CM. Replace it if it is subjected to an Impact.
1. Configurate the ABS/TCS HU/CM (only when replacing it).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Connector Removal Note
1. Release the lock lever to unlock it.
2. Remove the connector.
Brake Pipe Removal Note