Mazdaspeed6 L4-2.3L Turbo (2006)
Brake Pedal Assy: Testing and Inspection
BRAKE PEDAL INSPECTION
Brake Pedal Height Inspection
1. Verify that the distance from the insulator to the center of the upper surface of the pedal pad is as specified.
Brake pedal height (reference value) 187 mm (7.36 inch)
Brake Pedal Height Adjustment
Caution:
^
The brake switch may not operate normally after adjusting the pedal height. Whenever adjusting the pedal height, replace the brake switch with a
new one.
1. Loosen locknut B and turn the bolt A until it does not contact the pedal.
2. Loosen locknut D and turn rod C to adjust the height.
3. Tighten the bolt with locknut B.
Tightening torque 9.8 - 14.7 Nm (100 - 149 kgf-cm, 116 - 130 inch lbs.)
4. After adjustment, inspect the pedal play and the brake light operation.
Brake Pedal Play Inspection
1. Depress the pedal a few times to eliminate the vacuum in the system.
2. Remove the spring pin, verify that the holes in the fork and in the pedal are aligned, and reinstall the pin.
3. Gently depress the pedal by hand until resistance is felt, and check the pedal play.
Brake pedal play 0 - 3 mm (0 - 0.1 inch)
Brake Pedal Play Adjustment
