Mazdaspeed6 L4-2.3L Turbo (2006)
Brake Pedal Assy: Service and Repair
BRAKE PEDAL REMOVAL/INSTALLATION
Caution:
^
The clearance between the brake switch and the brake pedal is automatically adjusted to the correct amount when the brake switch connector is
connected after the brake switch has been properly installed. If the brake switch is not properly installed or the connector is connected before
installation, the clearance may be incorrect, causing a brake light malfunction. Therefore, always verify that the brake switch is properly installed
before connecting the connector.
^
Once the brake switch clearance has automatically been adjusted, It cannot be adjusted again. Therefore, replace the switch with a new one when
replacing the power brake unit or the pedal, or performing any procedure that changes the pedal stroke.
1. For models with an interlock cable unit, remove the lock unit with the brake switch.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Brake switch Installation Note
1. Fix the new brake switch on the brake pedal bracket or interlock cable unit by pressing down at 50 N 15.1 kgf, 11 lbs.).
