Mazdaspeed6 L4-2.3L Turbo (2006)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
DSC HU/CM Removal/Installation
DSC HU/CM REMOVAL/INSTALLATION
Caution:
^
When replacing the DSC HU/CM, configuration procedure must be done before removing the DSC HU/CM. If configuration is not completed
before removing the DSC HU/CM, DTC B2477 will be detected.
^
The internal parts of the DSC HU/CM could be damaged if dropped. Be careful not to drop the DSC HU/CM. Replace the DSC HU/CM if it is
subjected to an impact.
1. Configurate the DSC HU/CM (only when replacing it).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Perform the initialization procedures for the combined sensor.
Connector Removal Note
1. Release the lock lever to unlock it.
2. Remove the connector
Brake Pipe Removal Note