Mazdaspeed6 L4-2.3L Turbo (2006)
3) Install the left/right front shaft of the SST with front foot No.2 to the bolt as shown in the figure.
4) Adjust the positions of the SST side bars so that they are the same height (left and right) and horizontal.
5) Make sure each joint is securely tightened.
3. Support the engine using the SST.
Note:
-
The SST (49 E017 5AO) can be used in place of the SST (49 C01 7 5AO).
Engine Front Cover Removal Note
1. Remove the front oil seal using a flathead screwdriver or similar tool.
Chain Tensioner Removal Note
1. Press the timing chain tensioner ratchet to the left using a thin flathead screwdriver (precision screwdriver) to unlock the plunger.
