Mazdaspeed6 L4-2.3L Turbo (2006)
No.3 Engine Mount Rubber, No.3 Engine Joint Bracket Installation Note
1. Tighten the No.3 engine mount bracket stud bolts.
Tightening torque 7.0 - 13 Nm (71.4 - 132.5 kgf-cm, 62.0 - 115.0 inch lbs.)
2. Temporarily tighten the No.3 engine mount rubber installation bolts.
3. Install the No.3 engine joint bracket and tighten the bolts and nuts in the order shown in the figure.
Crankshaft Pulley Lock Bolt Installation Note
1. Install the SST to the camshaft as shown in the figure.
2. Verify that cylinder No. 1 is at TDC of the compression stroke. (Position crank weight contacts SST.)
3. To position the crankshaft pulley, temporarily tighten it and, using a suitable bolt (M6 X 1.0 length 25-35 mm (0.99-1.37 inch)), fix the crankshaft
pulley to the engine front cover.
