Mazdaspeed6 L4-2.3L Turbo (2006)
Blower Motor: Service and Repair
Blower Unit
Removal and Installation
BLOWER UNIT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Glove compartment
2. Console
3. Meter hood
4. Instrument cluster
5. Column cover
6. Lower panel
7. Steering shaft
8. A-pillar trim
9. Front scuff plate
10. Front side trim
11. Side panel
3. Remove the dashboard.
4. Remove the blower motor.
5. Remove the power MOS FET.
6. Remove the blower unit nuts.
7. Remove the screw securing the duct (2) to the A/C unit, by inserting a phillips screwdriver into the hole made after removing the blower motor.
8. Remove the screw securing the duct (2) to the A/C unit.
9. Remove the duct (2).