Mazdaspeed6 L4-2.3L Turbo (2006)
10. Remove the blower unit.
11. Temporary install the blower unit.
12. Install in the duct (2).
13. Install the two outer screws, securing the duct (2) to the A/C unit.
14. Install the screw on the end of the phillips screwdriver with the packing tape.
CAUTION: If the packing tape remains in the duct (2), it may become a source of noise. Wind up the packing tape to prevent pinching when
tightening the screw.
15. Install the duct (2) to the A/C unit by inserting a phillips screwdriver, with the screw, into the hole made after removing the blower motor.
16. Pull out the phillips screwdriver together with the packing tape.
17. Install the blower unit nuts.
18. Install the power MOS FET.
19. Install the blower motor.
20. Install the dashboard.
21. Connect the negative battery cable.
Disassembly/Assembly
BLOWER UNIT DISASSEMBLY/ASSEMBLY
