Mazdaspeed6 L4-2.3L Turbo (2006)
Fuel Gauge Sender: Service and Repair
FUEL GAUGE SENDER UNIT REMOVAL/INSTALLATION [AWD]
Fuel Gauge Sender Unit
1. Remove the fuel gauge sender unit.
2. Install in the reverse order of removal.
Fuel Gauge Sender Sub-Unit
WARNING:
-
Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and
eyes. To prevent this, always complete the "Fuel Line Safety Procedure".
-
A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before draining fuel, make
sure to discharge static electricity by touching a vehicle.
CAUTION:
Because the fuel tank is constructed such that the fuel level is higher than the installation surface of the fuel pump, fuel leakage could occur. If the
fuel gauge indicates a fuel level of half or more, perform the following Steps 1-14 to drain the fuel.
Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector.
Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of
foreign material.
1. Complete the "BEFORE REPAIR PROCEDURE.
2. Remove the plug hole plate.
3. Disconnect the quick release connector connected to the fuel distributor.
4. Connect a long hose to the disconnected quick release connector and drain the fuel into a container used for collecting gasoline.
5. Start the fuel pump using the following procedure.
Using WDS or equivalent
1. Connect the WDS or equivalent to the DLC-2.
2. Using the simulation function "FP", start the fuel pump.
Without using WDS or equivalent
