Mazdaspeed6 L4-2.3L Turbo (2006)
Air Bag(s) Arming and Disarming: Service and Repair
AIR BAG SYSTEM
SERVICE WARNINGS
Air Bag Module Inspection
-
Inspecting an air bag module using a tester can operate (deploy) the air bag module, which may cause serious injury. Do not use a tester to inspect
an air bag module. Always use the on-board diagnostic function to diagnose the air bag module for malfunctions.
Air Bag Module Handling
-
Handling a live (undeployed) air bag module that is pointed toward your body could result in serious injury if the air bag module were to
accidentally operate (deploy). When carrying a live (undeployed) air bag module, point the deployment surface away from your body to lessen the
chance of injury in case it operates (deploys).
-
A live (undeployed) air bag module placed with its deployment surface to ground is dangerous. If the air bag module were to accidentally operate
(deploy), it could cause serious injury. Always place a live (undeployed) air bag module with its deployment surface up.
Side Air Bag Module Handling
-
When a side air bag module operates (deploys) due to a collision, the interior of the seat back (pad, frame, trim) may become damaged. If a side
air bag does not operate (deploy) normally from a seat back that has been reused, a serious accident may result. After a side air bag has operated
(deployed), always replace both the side air bag module and the seat back (pad, frame, trim) with new parts. After servicing, verity that the seat
operates normally and that the wiring harness is not caught.
Seat Weight Sensor Handling
-
The passenger-side seat and the seat weight sensor may become deformed or otherwise damaged due to operation (deployment) of the front or side
air bag in an accident. This may cause the passenger sensing function to operate improperly and result in a serious accident. Always replace the
passenger seat and seat weight sensor with new ones after the front or side air bags have operated (deployed). After servicing, verify that the seat
operates normally and that the wiring harness is not caught. If the collision is not hard enough to cause the front or side air bags to operate
(deploy), inspect the seat weight sensor and replace it if there is any malfunction.
SAS Control Module Handling
-
Removing the SAS control module or disconnecting the SAS control module connector with the ignition switch at the ON position can activate the
sensor in the SAS control module and operate (deploy) the air bags and pre-tensioner seat belt, which may cause serious injury. Before removing
the SAS control module or disconnecting the SAS control module connector, always turn the ignition switch to the LOCK position, disconnect the
