Mazdaspeed6 L4-2.3L Turbo (2006)
Block joint type
1. Disconnect the block joint type pipes by grasping female side of the block with pliers or similar tool and holding firmly, then remove the
connection bolt or nut.
Refrigerant Lines Installation Note
1. When installing a new cooler pipe No. 4 or cooler hose (LO), add a supplemental amount of ATMOS GU10 compressor oil into the refrigeration
cycle.
Supplemental amount (approx. quantity)
5 ml (5 cc, 0.2 fl oz): Cooler pipe No. 4
10 ml (10 cc, 0.3 fl oz): Cooler hose (LO)
2. Apply compressor oil to the O-rings and connect the joints.
3. Tighten the joints.
Nut or block joint type
1. Tighten the nut or bolt of joint by hand.
2. Tighten the joint to the specified torque. If it is a nut join tighten the nut with a spanner and torque wrench.
3. Connect the block joint type pipes by grasping the female side of the block with pliers or similar tool and holding firmly, then tighten the
connection bolt or nut with a torque wrench.
