Mazdaspeed6 L4-2.3L Turbo (2006)
Vehicle Speed Sensor: Service and Repair
Vehicle Speed Sensor (VSS) Removal/Installation [FS5A-EL]
VEHICLE SPEED SENSOR (VSS) REMOVAL/INSTALLATION [FS5A-EL]
Caution:
^
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
^
If foreign materials are stuck to the VSS, disturbance by magnetic flux can cause sensor output to be abnormal and thereby negatively affect
control. Make sure that foreign materials such as iron filings are riot stuck to the VSS during installation.
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Disconnect the VSS connector.
4. Remove the VSS.
5. Apply ATF to a new O-ring and install it on a new VSS.
6. Install the VSS.
Tightening torque 8 - 11 Nm (82 - 112 kgf-cm, 71 - 97 inch lbs.)
7. Connect the VSS connector.
8. Install the undercover.
9. Connect the negative battery cable.
