Mazdaspeed6 L4-2.3L Turbo (2006)
1. Short the check connector terminal F/P to body GND using a jumper wire.
2. Turn the ignition switch to ON position to operate the fuel pump.
CAUTION: The fuel pump could be damaged if it is operated (fuel pump idling) while there is no fuel in the fuel tank. Verify the amount of fuel
being discharged from the hose and stop operation of the fuel pump when essentially no fuel is being discharged.
NOTE: If the fuel tank is full, drain approx. 40 L {10.6 US gal, 8.8 Imp gal} of fuel until the fuel gauge indicates approx. 3/8 of a tank.
6. Stop operation of the fuel pump when essentially no fuel is being discharged.
7. Reconnect the quick release connector to the fuel distributor.
8. Start the engine and idle it for 15 min (to transfer fuel from the sub-tank to the main tank).
9. Stop the engine.
10. Complete the "BEFORE REPAIR PROCEDURE".
11. Remove the plug hole plate.
12. Disconnect the quick release connector connected to the fuel distributor.
13. Connect a long hose to the disconnected quick release connector and drain the fuel into a container used for collecting gasoline.
14. Start the fuel pump using the following procedure.
Using WDS or equivalent