Mazdaspeed6 L4-2.3L Turbo (2006)
Open circuit
-
If there is no continuity, there is an open circuit. Repair or replace the wiring harness
-
Rear HO2S terminal A and PCM terminal 1Y
-
Rear HO2S terminal B and PCM terminal 2H
Short circuit
-
If there is continuity, there is a short circuit. Repair or replace the wiring harness.
-
Rear HO2S terminal A and body ground
-
Rear HO2S terminal A and power supply
-
Rear HO2S terminal B and power supply
Rear HO2S heater resistance inspection
1. Disconnect the rear HO2S connector.
2. Measure the rear HO2S resistance between terminals C and D.
-
If not within the specification, replace the HO2S.
Rear HO2S heater resistance 2-50 ohms
Rear HO2S circuit open/short inspection (heater)
1. Disconnect the PCM connector.
2. Disconnect the rear HO2S connector.
3. Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)
Open circuit
-
If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
-
Rear HO2S terminal C and ignition switch