Mazdaspeed6 L4-2.3L Turbo (2006)
Transmission Position Switch/Sensor: Service and Repair
TRANSAXLE RANGE (TR) SWITCH REMOVAL/INSTALLATION [FS5A-EL]
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
Caution:
^
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
3. Disconnect the TR switch connector.
4. Remove the clip and disconnect the selector cable.
Caution:
^
Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.
5. Set the adjustable wrench as shown to hold the manual shaft lever.
6. Remove the manual shaft nut and washer.
7. Remove the manual shaft lever.
8. Remove the TR switch.
9. Rotate the manual shaft to the converter housing side fully, then return 2 notches to set the N position.