Mazdaspeed6 L4-2.3L Turbo (2006)
1. Inspect the SST (Deployment tool).
2. Turn the ignition switch to the LOCK position.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Follow the appropriate procedure for deploying the driver-side air bag module, passenger-side air bag module, side air bag module, curtain air bag
module, or pre-tensioner seat belt.
Driver-side air bag module
WARNING: The driver-side air bag module is a dual inflator type. If one inflator is forced to operate (deploy), the other may operate (deploy)
accidentally. To prevent injury while disposing of the air bag module, make sure to operate (deploy) both driver-side air bag module inflators
simultaneously, following the procedure below.
1. Remove the driver-side air bag module.
2. Connect the SST (Adapter harness) to the driver-side air bag module as shown in the figure,
3. Place the driver-side air bag module on the center of the tire wheel with the module facing up. To secure the air bag module to the tire wheel, wrap
the wire through the wheel and around the bolt installation hole at least 4 times.
WARNING: If the air bag module is not properly installed to the tire wheel, serious injury may occur when the module is deployed.
When installing the air bag module to the tire wheel, make sure the module is facing up.
4. Stack three tires on top of the tire with the air bag module. Stack another tire that has a wheel on top of the four tires.
