Mazdaspeed6 L4-2.3L Turbo (2006)
Seat Belt: Service and Repair
Front Seat Belt
FRONT SEAT BELT REMOVAL/INSTALLATION
WARNING:
-
Handling the air bag system components improperly can accidentally operate (deploy) the air bag modules and pre-tensioner seat belts,
which may seriously injure you. Read the service warnings and cautions before handling the air bag system components.
-
The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-pillar, disconnect the negative battery
cable or work carefully, avoiding excessive impact to the lower part of the B-pillar.
CAUTION: The ELR has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR
will not work properly. Therefore, do not disassemble the retractor.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the B-pillar lower trim.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
-
If the air bag system warning light does not operate in the manner described above, there is a malfunction in the system. Inspect the system
using the on-board diagnostic function.
Pre-tensioner Seat Belt Connector Removal Note
1. Using a flathead screwdriver, pry out the pre-tensioner seat belt connector stopper plate.
2. Disconnect the pre-tensioner seat belt connector.
