Mazdaspeed6 L4-2.3L Turbo (2006)
Connect the WDS or equivalent to the DLC-2. Using the simulation function "FP", start the fuel pump.
Without using WDS or equivalent
1. Short the check connector terminal F/P to body GND using a jumper wire.
2. Turn the ignition switch to ON position to operate the fuel pump.
CAUTION: The fuel pump could be damaged if it is operated (fuel pump idling) while there is no fuel in the fuel tank. Verify the amount of fuel
being discharged from the hose and stop operation of the fuel pump when essentially no fuel is being discharged.
NOTE: If the fuel tank is full, drain approx. 55 L (15 US gal, 12 Imp gal) of fuel until the fuel gauge indicates E position.
15. Stop operation of the fuel pump when essentially no fuel is being discharged.
16. Disconnect the negative battery cable.
17. Complete the following in order to the work area.
1. Loosen the bolt of the fuel tank strap.
2. Lower the fuel tank to a position where the SST can be attached from the service hole cover.
18. Remove the rear seat cushion.
