Mazdaspeed6 L4-2.3L Turbo (2006)
10. Turn the protrusion at resistance between the terminals B and C become 750 ohms.
11. Install the TR switch while aligning the protrusion and groove as shown.
12. Hand-tighten the TR switch mounting bolts.
13. Inspect the resistance between the terminals B and C. If not as specified, readjust the TR switch.
Resistance 750 ohms
14. Tighten the TR switch mounting bolts.
Tightening torque 8 - 11 Nm (82 - 112 kgf-cm, 71 - 97 inch lbs.)
Caution:
^
Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, or the transaxle may be damaged.
15. Install the manual shaft lever and the washer.