Mazdaspeed6 L4-2.3L Turbo (2006)
1. Set the SSTs into the valve side.
2. Install the SST to the gear housing.
3. Press out the oil seal and inner guide.
Mounting Rubber Disassembly Note
^
Press the mounting rubber out from the gear housing using the SSTs and a press.
STEERING GEAR AND LINKAGE INSPECTION
Rack Inspection
1. Inspect the rack for cracking, damage, and tooth wear. Replace it as necessary.
2. Measure the runout of the rack.
Steering rack runout
Large diameter portion (near point A): 0.15 mm (0.006 inch) maximum
Small diameter portion (near point B): 0.20 mm (0.008 inch) maximum
3. If not within the specification, replace the rack.
Tie-rod End Inspection
1. Inspect the tie-rod end for damage and boot cracks. Replace it as necessary.
2. Inspect the ball joint for looseness. Replace the tie-rod end as necessary.
3. Rotate the ball joint five times.
4. Measure the rotation torque of the ball joint using the SST and a pull scale.