Mazdaspeed6 L4-2.3L Turbo (2006)
Rear Cross-Member: Service and Repair
Rear Crossmember Removal/Installation [AWD]
REAR CROSSMEMBER REMOVAL/INSTALLATION [AWD]
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove the middle pipe.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the rear wheel alignment.
