Mazdaspeed6 L4-2.3L Turbo (2006)
Rear Knuckle: Service and Repair
Wheel Hub, Hub Spindle Removal/Installation
WHEEL HUB, HUB SPINDLE REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while the vehicle is being serviced.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Locknut Removal Note
1. Knock the crimped portion of the locknut outward using a small cape chisel and a hammer.
2. Lock the hub by applying the brakes.
3. Remove the locknut.
ABS Sensor Rotor Removal Note
